Tankless Water Heater Installation Kit

The Eastman™ 1-IN OD gas tankless water heater connector kit is designed to connect most major brands of tankless water heaters and very high-usage appliances to a shut-off valve. The connector is certified for use with most tankless water heaters with gas ratings up to 290,900 BTUs. DuraCoat™ Epoxy Coating provides extra protection from corrosion, chemical stains from common household products, and UV rays and is approved for indoor/outdoor use. 

Includes (1) 24-IN 1-IN OD epoxy-coated gas range connector, (1) 1-IN FIP fitting, (1) 1-IN MIP (Tapped 3/4-IN FIP) fitting, (1) 3/4-IN FIP fitting, and (1) 3/4-IN MIP (Tapped 1/2-IN FIP) fitting, (1) leak detector solution, (1) thread sealant. The gas connector protects to be used for natural gas or LP tankless water heaters and very high-usage appliances. The connector protects certified for indoor and outdoor use on appliances up to 290,900 BTUs. DuraCoat epoxy coating protects against corrosion, stains, and UV.

• For tankless water heaters with gas ratings up to 290,900 BTUs.
• Gas connector and fittings used for Natural Gas and Liquid Propane (LP).
• Approved for indoor and outdoor use.
• Easy to install, no special tools required.
• Stainless steel flexible connectors with deep corrugations enhance flexibility.
• DuraCoat epoxy coating protects against corrosion, stains, and UV.
• Includes: 24-IN gas connector, fittings, thread sealant, and leak detector.
• Temperature rating: -20 Degrees F to 150 Degrees F+.
• 100% Leak Tested - Factory tested for peace of mind.
• Certified to: ANSI Z 21.24/CSA 6.10, ANSI Z 21.69/CSA 6.16, ANSI Z 21.75/CSA 6.27, Commonwealth of Massachusetts Board of State Examiners (except 48", 60", 72"), City of New York-MEA #376-92-M.